Honda Accord 2008 Manual page 1290

07/11/02 09:19:40 61TA0000_170_0024
33. Install the spring (A) in the pump housing.
＊１８
D
49 N·m
(5.0 kgf·m,
36 lbf·ft)
34. Coat the pressure control valve (B) with power
steering fluid, and install it in the pump housing.
35. Coat the new 16.7 mm O-ring (C) with power
steering fluid, and install it on the pressure control
valve cap (D).
36. Install the pressure control valve cap on the pump
housing, and tighten it to the specified torque.
37. Coat the new 14.8 mm O-ring (A) with power
steering fluid, and install it on the inlet joint (B).
Install the inlet joint with a flange bolt (C) on the
pump housing, and tighten to the specified torque.
＊１９
B
C
Replace.
A
Replace.
38. Check that the power steering pump turns
smoothly by turning the pulley by hand. If it is hard
A
to turn, loosen the four flange bolts on the pump
cover, then retighten them in the same manner as
in step 30. Retest. If the power steering pump is still
hard to turn, replace the power steering pump.
39. Reinstall the power steering pump (see page 17-16).
C
6 x 1.0 mm
11 N·m
(1.1 kgf·m,
8 lbf·ft)
B
17-23