Honda Accord 2008 Manual page 1176

07/11/02 09:22:15 61TA0000_140_0333
4. Remove the stator shaft (E) and the stator shaft
stop (F), then remove the regulator separator plate
(G) and the two dowel pins (H).
5. Remove the servo body (I) (12 bolts), then remove
the separator plate (J) and the two dowel pins (K).
6. Remove the cooler check valve spring (L) and the
valve (M), then remove the main valve body (N)
(three bolts). Do not let the two check balls (O) fall
out, and do not use a magnet to remove the check
balls, it may magnetize them.
7. Remove the ATF pump driven gear shaft (P), then
remove the ATF pump driven gear (Q) and the ATF
pump drive gear (R).
8. Remove the main separator plate (S) and the two
dowel pins (T).
9. Remove the ATF magnet (U), clean and reinstall it
in the torque converter housing (V).
10. Clean the inlet opening (A) of the ATF strainer (B)
thoroughly with compressed air, then check that it
is in good condition and that the inlet opening is
not clogged.
＊０２
B
A
11. Test the ATF strainer by pouring clean ATF through
the inlet opening, and replace it if it is clogged or
damaged.
12. Remove the O-rings (W) (X) from the stator shaft
and the ATF strainer. Install new ones when
installing the valve bodies.
14-331