Honda Accord 2008 Manual page 1645

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:30:28 61TA0000_200_0078

Quarter Glass Replacement

• Put on gloves to protect your hands.

• Wear eye protection when removing the glass with

• Use seat covers to avoid damaging any surfaces.

• The quarter glass clips and the molding clips will

need replacement because they will be damage

during glass removal.

1. Remove these items:

• C-pillar trim (see page 20-110)

• Rear side trim panel (see page 20-118)

• B-pillar upper trim (see page 20-105)

2. Remove the front seal (A) from the front edge of the

quarter glass (B). If necessary, cut the seal with a

utility knife.

3. Apply protective tape along the inside and outside

edges of the body. From pillar side the vehicle, use

a utility knife (A) to cut the front clips (B) of the

quarter glass molding (C).

4. Using an awl, make a hole through the adhesive

from inside the vehicle at the front corner portion

of the quarter glass. Push a piece of piano wire

through the hole, and wrap each end around a

piece of wood.

5. With a helper on the outside, pull the piano wire (A)

back and forth in a sawing motion. Hold the piano

wire as close to the quarter glass (B) as possible to

prevent damage to the body, and carefully cut

through the adhesive (C) in the straight areas and

the front corners, but not the rear corner.

ＴＡ０８ＡＢ２Ｊ５４４０００４８１０１ＫＢＡＴ１０

Chapters

Table of Contents