Honda Accord 2008 Manual page 1036

07/11/02 09:16:46 61TA0000_140_0193
12. Disconnect PCM connector B (49P).
13. Measure the resistance between PCM connector
terminals B27 and C44.
＊０２
B (49P)
SH D (GRN/RED)
Is there 12 25
YES
NO −
14. Disconnect the shift solenoid harness connector.
15. Check for continuity between PCM connector
terminal B27 and shift solenoid harness connector
terminal No. 8.
＊０３
SHIFT SOLENOID
HARNESS CONNECTOR
SH D (GRN/RED)
Wire side of
female terminals
Is there continuity?
YES
−
NO
connector terminal B27 and the shift solenoid
harness connector, then go to step 18.
PCM CONNECTORS
C (49P)
Terminal side of female terminals
− ?
−
Go to step 24.
Go to step 14.
PCM CONNECTOR B (49P)
SH D (GRN/RED)
Terminal side of
female terminals
− Go to step 16.
Repair open in the wire between PCM
16. Remove the shift solenoid harness (see page
14-226).
17. Check for continuity between shift solenoid
harness connector terminal No. 8 and the shift
solenoid valve D connector terminal.
SHIFT SOLENOID
HARNESS CONNECTOR
LG1 (BRN/YEL)
Terminal side of
male terminals
Is there continuity?
YES −
14-226), then go to step 18.
−
NO
14-226), then go to step 18.
18. Reconnect all connectors.
19. Turn the ignition switch to ON (II).
20. Clear the DTC with the HDS.
21. Start the engine with the shift lever in P, and wait
for at least 1 second.
22. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0983 indicated?
YES −
terminals between shift solenoid valve D and the
PCM, then go to step 1.
NO −
SHIFT SOLENOID
VALVE D
CONNECTOR
SH D (YEL)
Wire side of
female terminals
Replace shift solenoid valve D (see page
Replace the shift solenoid harness (see page
Check for poor connections or loose
Go to step 23.
＊０４
(cont'd)
14-191