Honda Accord 2008 Manual page 1227

07/11/02 09:24:05 61TA0000_140_0384
Transmission End Cover
End Cover Installation (cont'd)
10. Lubricate the threads of the shafts, new locknuts,
and new conical spring washers with ATF.
11. Install new conical spring washers (A) with facing
stamped mark side up in the direction shown, and
install a new mainshaft locknut (B), a new
countershaft locknut (C), and a new secondary
shaft locknut (D).
＊０４
12. Tighten the locknuts to 167 N·m (17.0 kgf·m,
123 lbf·ft).
NOTE:
• Be sure to install the conical spring washers in
the direction shown.
• Use a torque wrench to tighten the locknut. Do
not use an impact wrench.
• Countershaft and secondary shaft locknuts have
left-hand threads.
13. Remove the mainshaft holder from the mainshaft.
14. Stake the locknuts into the shafts to a depth (A) of
0.7 1.3 mm (0.03 0.05 in.) using a 3.5 mm punch −
(B).
＊０５
14-382
B
C
D
−
A
15. Saitama Factory produced models: Install the
selector control lever (A) on the selector control
shaft (B), and install the bolt with a new lock
washer (C), then bend the lock tab of the lock
washer against the bolt head.
A
A
B
16. Set the park lever in the P position, then check that
the park pawl (A) engages the park gear (B).
C
F
6 x 1.0 mm
14 N·m
(1.4 kgf·m,
10 lbf·ft)
17. If the park pawl does not engage fully, check the
distance (C) between the park pawl shaft (D) and
the park lever roller pin (E) (see page 14-321).
18. Tighten the lock bolt, and bend the lock tab of the
lock washer (F) against the bolt head.
B
C
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
B
A
E
D
＊０６
＊０７