Honda Accord 2008 Manual page 1107

07/11/02 09:19:17 61TA0000_140_0264
Automatic Transmission
Transmission Installation (cont'd)
41. Install the damper forks (A) over the driveshaft and
onto the lower arms (B) (see step 4 on page 18-33).
Loosely install the damper pinch bolts (C) into the
damper forks.
＊２０
A
E
12 x 1.25 mm
64 N·m
(6.5 kgf·m,
47 lbf·ft)
Replace.
I
10 x 1.25 mm
48 N·m
(4.9 kgf·m,
35 lbf·ft)
J
Replace.
42. Connect the damper forks and the lower arms with
a new damper fork mounting bolts (D), then loosely
tighten a new mounting nuts (E).
43. Install the ball joints (F) on the lower arm with the
castle nut (G) and new cotter pin (H) (see page
18-21).
44. Install the tie-rod end ball joints to each knuckle
with the nuts (I) and new cotter pins (J) (see step 29
on page 17-62).
45. Tighten the lower arm self-locking nuts to the
specified torque.
14-262
C
10 x 1.25 mm
49 N·m (5.0 kgf·m, 36 lbf·ft)
D
Replace.
B
G
14 x 1.5 mm
78 80 N·m −
(8.0 9.0 kgf·m, 58 65 lbf·ft) − −
46. Position the steering gearbox on the rear engine
mount base bracket.
47. Secure the power steering fluid line clamp (A) with
the bolt.
A
48. Secure the power steering fluid line (B) with the
clamp (C).
F
H
Replace.
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
B
C
＊２１