Honda Accord 2008 Manual page 1662

07/11/02 09:31:15 61TA0000_200_0095
10. Install the slider and cable assembly in the reverse
order of removal, and note these items:
• Damaged parts should be replaced.
• Apply multipurpose grease to the glass bracket
(A) and the guide rail portion of the frame (B)
indicated by the arrows.
• Before reinstalling the motor, make sure both
link lifters are parallel, and in the tilt-up position.
• Before reinstalling the motor, install the frame
and the glass, then check the opening drag
(see page 20-93).
• After reinstalling the motor, reset the moonroof
control unit (see page 22-350).
＊０６
Closing Force and Opening Drag
Check
1. Remove the headliner (see page 20-130).
2. Closing force check:
• With a shop towel (A) on the leading edge of the
glass (B), attach a spring scale (C) as shown.
• Have an assistant hold the switch to close the
glass while you measure the force required to
stop it.
• Read the force as soon as the glass stops moving,
then immediately release the switch and the
spring scale.
Closing force: 200 290 N (20 30 kgf, 44 66 lbf)
A
A
3. If the force in not within specification, remove the
moonroof motor (see page 20-88), then check:
B
• The gear teeth and the inner cable for breakage
and damage. If the gear teeth are broken, replace
the motor. If the inner cable is damaged, remove
the frame (see page 20-88), and replace the cable
(see page 20-91).
• The moonroof motor (see page 22-352). If the
motor fails to run or doesn't turn smoothly,
replace it.
• The opening drag. Go to step 4.
ＴＡ０８ＡＢ９Ｊ３４２００００００００ＦＥＡＴ００
− −
B
C
−
＊０１
(cont'd)
20-93 20-93