Honda Accord 2008 Manual page 1727

07/11/02 09:34:18 61TA0000_200_0160
Dashboard
Center Display Visor Removal/Installation (cont'd)
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
With Navigation System
NOTE:
• Take care not to scratch the dashboard and its related
parts.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Remove these items:
• Center pocket (see page 20-155)
• Driver's inner dashboard trim (see page 20-153)
• Passenger's dashboard trim (see page 20-159)
• Dashboard center vent (see page 20-163)
2. Remove the center display visor (A).
–1 Remove the screws (B).
–2 Pull out the upper edge of the visor to detach
–3 Pull out the visor to detach the side clips (D).
＊０１
Fastener Locations
B
E
B
20-158
the upper clips (C).
NOTE: If the non-woven fabric (E) on the C clip
is damaged, replace it with a new one.
: Screw, 2 C, D : Clip, 6
C
C
C
C
D
C
D
B
A
3. Install the cover in the reverse order of removal,
and note these items:
• If the clips are damaged, replace them with new
ones.
• If the upper clip is replaced, attach the new
non-woven fabric (A) around new clip (B) as the
following procedures.
– After installing new clip to the visor (C), clean
the clip and the visor surfaces with a sponge
dampened in alcohol. After cleaning, keep oil,
grease, and water from getting on the surface.
– Attach the non-woven fabric with adhesive
tape around the clip.
• Push the clips into place securely.
Non-woven fabric:
Thickness 0.5 mm (0.02 in.)
Width 20 mm (0.79 in.)
Length 25 mm (0.98 in.)
Non-woven fabric adhesive tape:
Thickness 0.16 mm (0.006 in.)
Width 20 mm (0.79 in.)
Length 25 mm (0.98 in.)
B
C
ＴＡ０８ＡＮ１Ｊ２６２２０２１６４３５ＫＤＡＴ０２
＊０２
A