Honda Accord 2008 Manual page 1223

07/11/02 09:23:38 61TA0000_140_0380
Transmission Housing
Shaft Assembly and Housing Installation (cont'd)
7. Install the selector control shaft (A) in the torque
converter housing aligning the manual valve lever
pin (B) on the selector control shaft with the guide
of the manual valve (C). Pull the manual valve
gently when aligning the manual valve with the
selector control shaft.
＊０４
A
B
8. Hook the detent spring (A) to the detent arm (B).
＊０５
A
B
14-378
9. Turn the shift fork shaft (A) so the large chamfered
hole (B) is facing the fork bolt hole (C) of the shift
fork (D).
6 x 1.0 mm
14 N·m
(1.4 kgf·m, 10 lbf·ft)
C
10. Install the shift fork and the reverse selector
together on the shift fork shaft and the countershaft
subassembly. Secure the shift fork to the shift fork
shaft with the lock bolt and a new lock washer (E),
then bend the lock tab of the lock washer against
the bolt head.
11. Install the needle bearing and the countershaft
reverse gear on the countershaft subassembly.
12. Install the reverse idler gear in the transmission
housing (see page 14-329).
13. Install the idler gear shaft/idler gear assembly
(see page 14-355), if it was removed.
D
C
E
B
A
＊０６