Honda Accord 2008 Manual page 1757

07/11/02 09:37:08 61TA0000_200_0190
Seats
Front Seat Lumbar Support
Replacement (cont'd)
7. Remove the lumbar support motor cover (A).
–1 Release the cover from the lower hooks (B).
–2 Pull the cover upward to release it from the
＊０４
8. Disconnect the lumbar support motor connector (A),
and detach the harness clip (B). Remove the nuts,
then remove the lumbar support motor (C).
＊０５
Fastener Locations
9. Install the lumbar support in the reverse order of
removal, and note these items:
• Make sure the connector is plugged in properly.
• To prevent wrinkles when installing a seat-back
cover, make sure the material is stretched evenly
over the pad before securing the hook strips.
• Replace the back panel clips with new ones.
20-188 20-188
upper hook (C).
C
B
: Nut, 2
A
B
Front Seat Slide Motor
Replacement
SRS components are located in this area. Review the
SRS component locations (see page 24-19) and the
precautions and procedures (see page 24-23) before
doing repairs or service.
4-door Driver's Seat (10-way Power Seat)
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear the seams or damage the seat
A
covers.
1. Remove the front seat (see page 20-180).
2. Remove the flex cable (A) and the cable housing (B).
–1 Release the housing from the hooks (C).
–2 Disconnect the cable from the worm gear (D) in
the inner seat track by pulling out the housing.
–3 Disconnect the cable from the slide motor (E).
NOTE: Take care not to kink the cable.
6 x 1.0 mm
6.3 N·m
(0.64 kgf·m,
4.6 lbf·ft)
C
ＴＡ０８ＡＱＥＪ４６１２７０４６５０１ＫＢＡＴ０１
A
D
B
B
C
E
＊０１