Honda Accord 2008 Manual page 1246

07/11/02 09:17:11 61TA0000_160_0007
2. Remove the boot bands. Be careful not to damage
the boot and dynamic damper.
• If the boot band is a welded type (A), cut the boot
band.
• If the boot band is a double loop type (B), lift up
the band end (C), and push it into the clip (D).
• If the boot band is a low profile type (E), pinch the
boot band using commercially available boot
band pliers (F).
Welded type
＊０２
Double loop type
＊０３
Low profile type
＊０４
A
C
B
D
E
3. Make marks (A) on each roller (B) and the inboard
joint (C) to identify the locations of the rollers to the
grooves in the inboard joint. Then remove the
inboard joint on a clean shop towel (D). Be careful
not to drop the rollers when separating them from
the inboard joint.
NOTE: Do not engrave or scribe any marks on the
rolling surface.
C
D
4. Make marks (A) on the rollers (B) and the spider (C)
to identify the locations of the rollers on the spider,
then remove the rollers.
NOTE:
• Do not engrave or scribe any marks on the rolling
surface.
• If necessary, use a commercially available puller.
B
D
A
F
5. Remove the circlip (D).
6. Mark the spider and driveshaft (E) to identify the
position of the spider on the shaft.
7. Remove the spider.
A
B
A
C
E
(cont'd)
16-7
＊０５
＊０６