Wheel Bearing End Play Inspection; Wheel Runout Inspection - Honda Accord 2008 Manual

07/11/02 09:27:30 61TA0000_180_0008
Front and Rear Suspension

Wheel Bearing End Play Inspection

1. Raise the vehicle, and support it with safety stands
in the proper locations (see page 1-9).
2. Remove the wheels.
3. Install suitable flat washers (A) and the wheel nuts.
Torque the nuts to the specified torque to hold the
brake disc securely against the hub.
Front
＊０１
Rear
＊０２
108 N·m
(11.0 kgf·m, 79.6 lbf·ft)
4. Attach the dial gauge. Place the dial gauge against
the hub flange.
5. Measure the bearing end play while moving the
brake disc inward and outward.
Wheel bearing end play:
Front/Rear: 0 0.05 mm (0 0.002 in.)
6. If the bearing end play measurement is more than
the standard, replace the wheel bearing or the hub
bearing unit.
18-8 18-8
ＴＡ０８Ａ００Ｂ２０２０００６５２０１ＭＡＡＴ００
A
108 N·m
(11.0 kgf·m, 79.6 lbf·ft)
A
− −

Wheel Runout Inspection

1. Raise the vehicle, and support it with safety stands
in the proper locations (see page 1-9).
2. Check for a bent or deformed wheel.
3. Set up the dial gauge as shown, and measure the
axial runout by turning the wheel.
Front and rear wheel axial runout:
Standard:
Steel wheel: 0 1.0 mm (0 0.04 in.) −
Aluminum wheel: 0 0.7 mm (0 0.03 in.) −
Service limit: 2.0 mm (0.08 in.)
ＴＡ０８Ａ００Ｂ５４１００００００００ＭＡＡＴ０２
−
−
＊０１