Honda Accord 2008 Manual page 1613

07/11/02 09:29:46 61TA0000_200_0046
Doors
Rear Door Glass and Regulator Replacement (cont'd)
10. Disconnect the connector (A) from the regulator (B).
＊０８
Fastener Locations
C
B
11. Remove the bolts (C), and loosen the bolt (D), then
remove the regulator through the hole in the door.
20-44
: Bolt, 4 D : Bolt, 1
(Black) (Silver)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
C
D
C
C
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
12. Apply multipurpose grease to all the sliding
surfaces of the regulator (A) where shown.
A
A
13. Install the glass and regulator in the reverse order
of removal, and note these items:
• Roll the glass up and down to see if it moves
freely without binding.
• Make sure that there is no clearance between the
glass and glass run channel when the glass is
closed.
• Adjust the position of the glass as necessary
(see page 20-50).
• Do the power window control unit reset
procedure (see page 22-253).
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
• Check for water leaks (see step 8 on page 20-51).
• Test-drive and check for wind noise and rattles.
• Make sure the power door locks and windows
operate properly.
＊０９
A