Honda Accord 2008 Manual page 1075

07/11/02 09:18:10 61TA0000_140_0232
Automatic Transmission
A/T Clutch Pressure Control Solenoid Valve A Replacement
1. Remove the intake air duct.
2. Disconnect the A/T clutch pressure control solenoid
valve A connector.
3. Remove the bolts securing the ATF cooler inlet line
brackets (B).
＊０１
E
D
F
4. Remove the mounting bolts and A/T clutch
pressure control solenoid valve A.
5. Remove the ATF pipe (C), the ATF joint pipes (D),
the O-rings (E), and the gasket (F).
6. Clean the mounting surface and fluid passages of
the transmission housing.
7. Install a new gasket on the transmission housing,
and install the ATF pipe and the ATF joint pipes.
NOTE: Be sure to install a new gasket with the blue
side toward the transmission housing.
8. Install new O-rings over the ATF joint pipes.
9. Install a new A/T clutch pressure control solenoid
valve A.
10. Secure the ATF cooler inlet line brackets with the
bolts.
14-230
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
C
6 x 1.0 mm
12 N·m
B
(1.2 kgf·m, 8.7 lbf·ft)
11. Check the A/T clutch pressure control solenoid
valve A connector for rust, dirt, or oil, and clean if
necessary, then connect the connector securely.
12. Install the intake air duct.
A
B
ＴＡ０８ＡＥＢＥ１０４１０６１２２２３ＫＢＡＴ２０