Honda Accord 2008 Manual page 1220

07/11/02 09:23:36 61TA0000_140_0377
NOTE: Refer to the Exploded View as needed during the
following procedures.
1. Make sure that the ATF magnet is clean and
installed in the torque converter housing.
2. Install the main separator plate (A) and the two
dowel pins on the torque converter housing. Then
install the ATF pump drive gear (B), the ATF pump
driven gear (C), and the ATF pump driven gear
shaft (D). Install the ATF pump driven gear with its
grooved and chamfered side facing down.
＊０４
3. Install the main valve body.
4. Make sure the ATF pump drive gear (A) rotates
smoothly in the normal operating direction, and the
ATF pump driven gear shaft (B) moves smoothly in
the axial and normal operating direction.
＊０５
A
D
C
B
5. If the ATF pump drive gear and the ATF pump
driven gear shaft do not move smoothly, loosen the
main valve body bolts. Realign the ATF pump
driven gear shaft, and retighten the bolts to the
specified torque, then recheck. Failure to align the
ATF pump driven gear shaft correctly will result in
a seized ATF pump drive gear or ATF pump driven
gear shaft.
6. Make sure that the two check balls and the cooler
check valve are in the main valve body, then install
the cooler check valve spring in the cooler check
valve.
B
7. Install the servo separator plate and the two dowel
pins on the main valve body.
8. Install the servo body (12 bolts). Install the ATF
strainer with the two bolts in the bolt holes (A) in
step 12, and install the baffle plate with the two
A
bolts in the bolt holes (B) (see step 2 on page
14-377).
A
9. Install the regulator separator plate and the two
dowel pins on the main valve body.
10. Install a new O-ring on the stator shaft, and install
the stator shaft and the stator shaft stop.
11. Install the regulator valve body (eight bolts).
12. Install a new O-ring on the ATF strainer, and install
the ATF strainer (two bolts).
13. Install the ATF joint pipes (one bolt).
14. Install the ATF feed pipes in the regulator valve
body and the servo body.
B
B
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
14-375
＊０６