Honda Accord 2008 Manual page 1122

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:19:27 61TA0000_140_0279

9. If improperly installed, remove the shift cable from

the shift lever bracket base, and reinstall the shift

cable. Do not install the shift cable end on the

mounting stud while the shift cable is on the shift

lever bracket base.

10. Install and tighten the nut on the shift cable end.

11. Remove the 6.0 mm (0.24 in.) pin that was installed

to hold the shift lever.

12. Turn the ignition switch to ON (II). Move the shift

lever to each position, and check that the A/T gear

position indicator follows the transmission range

13. Shift to P, and check that the shift lock works

properly. Push the shift lock release, and check that

the shift lever releases, and also check that the shift

lever locks when it is shifted back to P.

14. Reinstall these items:

• Center console (see page 20-147)

• Center console rear trim (see page 20-148)

• Center console panel (see page 20-145)

22 N·m (2.2 kgf·m, 16 lbf·ft)

Chapters

Table of Contents