Honda Accord 2008 Manual page 1368

07/11/02 09:28:05 61TA0000_180_0035
NOTE: When compressing the damper spring, use a
commercially available strut spring compressor
(Branick MST-580A or Model 7200, or equivalent)
according to the manufacturer's instructions.
Disassembly
1. Compress the damper spring, then remove the self-
locking nut (A) while holding the damper shaft with
a hex wrench (B). Do not compress the damper
spring more than necessary to remove the self-
locking nut.
＊０２
2. Release the pressure from the strut spring
compressor, then disassemble the damper as
shown in the Exploded View.
Inspection
1. Reassemble all the parts, except for the damper
2. Compress the damper assembly by hand, and
B
A
10 x 1.25 mm
Replace.
3. Check for oil leaks, abnormal noises, and binding
spring.
check for smooth operation through a full stroke,
both compression and extension. The damper
should extend smoothly and constantly when
compression is released. If it does not, the gas is
leaking and the damper should be replaced.
during these tests.
＊０３
(cont'd)
18-35