Honda Accord 2008 Manual page 833

07/11/02 09:25:17 61TA0000_130_0060
Manual Transmission
Transmission Reassembly (cont'd)
17. Clean any dirt or oil from the change lever
assembly sealing surface. Apply liquid gasket
(P/N 08718-0002) to the sealing surface.
NOTE: Do not install the change lever assembly if
4 minutes or more have passed after applying the
liquid gasket. Instead, remove the old residue and
reapply the liquid gasket.
＊１３
18. Install the 8 x 14 mm dowel pins (A) and the change
lever assembly (B).
＊１４
6 x 1.0 mm
12 N·m (1.2 kgf·m, 91 lbf·ft)
19. Apply liquid gasket (P/N 08718-0002) to the threads
of the interlock bolt (C), and install it on the
transmission housing.
13-60
Liquid gasket
C
39 N·m
A
(4.0 kgf·m,
29 lbf·ft)
A
B
20. Install the filler plug (A) with a new washer finger-
tight, and install the drain plug (B) and 10 mm
flange bolt (C) with new sealing washers (D).
A
44 N·m
(4.5 kgf·m, 33 lbf·ft)
E
Replace.
G
F
6 x 1.0 mm
12 N·m (1.2 kgf·m, 9 lbf·ft)
21. Install the new O-ring (E), plain washer (F), and
output shaft (countershaft) speed sensor (G).
22. Install the detent bolts (A), springs, and steel balls
with new sealing washers (B).
B
Replace.
E
A
22 N·m
C
(2.2 kgf·m,
Replace.
16 lbf·ft)
10 x 1.25 mm D
44 N·m 44 N·m
(4.5 kgf·m, (4.5 kgf·m,
33 lbf·ft) 32 lbf·ft)
23. Install a new 20 mm sealing washer (C), 20 mm bolt
(D), and transmission hanger (E).
24. Apply liquid gasket (P/N 08718-0002) to the threads
of the back-up light switch (F), and install it in the
transmission housing.
B
39 N·m
(4.0 kgf·m,
29 lbf·ft)
D
Replace.
D
Replace.
C
44 N·m
(4.5 kgf·m, 33 lbf·ft)
F
29 N·m
(3.0 kgf·m,
22 lbf·ft)
＊１５
＊１６