07/11/02 08:48:07 61TA0000_140_0107
21. Connect PCM connector B (49P).
22. Turn the ignition switch to ON (II).
23. Measure the voltage between input shaft
(mainshaft) speed sensor connector terminal No. 2
and body ground.
*04
Is there about 5 V ?
YES
sensor (see page 14-236), then go to step 30.
−
NO
INPUT SHAFT (MAINSHAFT)
SPEED SENSOR CONNECTOR
NM (WHT/RED)
Wire side of female terminals
−
Replace the input shaft (mainshaft) speed
Go to step 24.
24. Turn the ignition switch to LOCK (0).
25. Disconnect PCM connector B (49P).
26. Check for continuity between PCM connector
terminal B18 and input shaft (mainshaft) speed
sensor connector terminal No. 2.
PCM CONNECTOR B (49P)
NM (WHT/RED)
Terminal side of
female terminals
Is there continuity?
YES
−
Go to step 36.
−
NO
Repair open in the wire between PCM
connector terminal B18 and the input shaft
(mainshaft) speed sensor, then go to step 30.
INPUT SHAFT
(MAINSHAFT)
SPEED SENSOR
CONNECTOR
NM
(WHT/RED)
Wire side of
female terminals
(cont'd)
14-105
*05