Honda Accord 2008 Manual page 1602

07/11/02 09:29:10 61TA0000_200_0035
Front Door Outer Molding Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• If you remove the door outer molding, replace it with
a new one because it will bend during removal.
• Put on gloves to protect your hands.
• Take care not to scratch the door.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
• 4-door is shown; 2-door is similar.
1. Remove the power mirror (see page 20-55).
2. Using a clip remover, detach the clip, then pull back
the door weatherstrip (A), and remove the screw.
＊０１
Fastener Locations
:Clip, 1
(Black)
: Screw, 1
A
3. While removing the upper edge of the door outer
molding (A) from the edge of the sash, cut the
double-sided adhesive tape (B) with a utility knife,
then remove the molding from the sash, and
remove the molding from between the door glass
outer weatherstrip (C) and the door.
A
A
B
C
4. Scrape off the remaining double-sided adhesive
tape from the sash, then clean the sash surface
with a sponge dampened in isopropyl alcohol.
5. Install the new door outer molding in the reverse
order of removal, and note these items:
• Insert the front edge of the molding between the
door glass outer weatherstrip and the door
properly.
• Push the adhesive portions into place securely.
• Make sure the upper and lower sides of the
molding are catching the edges of the sash
properly.
• Push the door weatherstrip clip into place
securely.
ＴＡ０８Ａ００Ｊ１６１２６７２１２０１ＫＢＡＴ１０
＊０２
A
20-33