Honda Accord 2008 Manual page 1641

07/11/02 09:30:26 61TA0000_200_0074
Glass
Rear Window Replacement (cont'd)
15. Set the rear window in the opening, and center it.
Make alignment marks (A) across the rear window
and body with a grease pencil at the four points
shown. Make sure the pins (B) of both upper clips
(C) contact with the edge of the body holes. Be
careful not to touch the rear window where
adhesive will be applied. 4-door is shown; 2-door is
similar.
＊１２
16. Remove the rear window.
20-72
C
B
17. With a sponge, apply a light coat of glass primer to
the rear window (A) along the edge of the rubber
dams (B) as shown, then lightly wipe it off with
gauze or cheesecloth:
• With the printed dots (C) on the rear window as a
guide, apply the glass primer to both corner
portions of the rear window.
• Do not apply body primer to the rear window,
and do not get body and glass primer sponges
mixed up.
• Never touch the primed surfaces with your hands.
If you do, the adhesive may not bond to the rear
window properly, causing a leak after the rear
A
window is installed.
• Keep water, dust, and abrasive materials away
from the primed surfaces.
2-door
: Apply glass primer here.
11 mm
(0.43 in.)
A
11 mm
(0.43 in.)
B
12 mm
(0.47 in.)
Inside
Inside
B
B
A
C
B
5 mm
(0.2 in.)
C
5 mm
5 mm (0.2 in.)
(0.2 in.)
A
B
Inside
5 mm
(0.2 in.)
B
＊１３
B
A
B
C
B
C
B