Mainshaft Thrust Clearance Adjustment - Honda Accord 2008 Manual

07/11/02 09:25:14 61TA0000_130_0055

Mainshaft Thrust Clearance Adjustment

Special Tools Required
• Mainshaft holder 07GAJ-PG20110
• Mainshaft base 07GAJ-PG20130
1. Remove the 72 mm shim (A) and oil guide plate M
from the transmission housing (B).
＊０１
2. Thoroughly clean the 28 mm spring washer (A) and
28 mm washer (B) before installing them on the
clutch housing side ball bearing (C). Note the
installation direction of the spring washer.
＊０２
3. Install the 3rd/4th synchro hub, the distance collar,
the 5th synchro hub, the MBS distance collar, and
the angular ball bearing on the mainshaft.
NOTE: Refer to the mainshaft reassembly Exploded
View (see page 13-39).
C
4. Install the mainshaft in the clutch housing.
5. Place the transmission housing over the mainshaft
and onto the clutch housing.
6. Tighten the clutch and transmission housings with
several 8 mm bolts.
NOTE: It is not necessary to use sealing agent
A
between the housing for this procedure.
7. Lightly tap on the mainshaft with a plastic hammer.
M
8. Attach the mainshaft holder (A) and mainshaft base
(B) to the mainshaft as follows:
• Back out the mainshaft holder bolt (C), and
loosen the two hex bolts (D).
• Fit the holder over the mainshaft so its lip is
towards the transmission.
• Align the mainshaft holder lip around the groove
B
at the inside of the mainshaft splines, then
tighten the hex bolts.
C
B
A
9. Fully seat the mainshaft by tapping its end with a
plastic hammer.
10. Thread the mainshaft holder bolt in until it just
contacts the wide surface of the mainshaft base.
ＴＡ０８ＡＥＡＥ３４１５０４０００００ＭＢＡＴ００
A
07GAJ-PG20110
D
B
07GAJ-PG20130
(cont'd)
13-55
＊０３