Regulator Valve Body Disassembly, Inspection, And Reassembly - Honda Accord 2008 Manual

07/11/02 09:22:17 61TA0000_140_0338
Valve Body

Regulator Valve Body Disassembly, Inspection, and Reassembly

1. Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages.
2. Inspect the valve body for scoring and damage.
3. Check all valves for free movement. If any fail to slide freely, refer to the valve body repair procedure (see page
14-332).
4. Hold the regulator spring cap in place while removing the stop bolt. The regulator spring cap is spring loaded.
5. Coat all parts with ATF during assembly.
6. When reassembling the valve body, align the hole in the regulator spring cap with the hole in the valve body, then
press the spring cap into the valve body, and tighten the stop bolt.
＊０１
SPRING SPECIFICATIONS
A
B
C
D
E
F
G
H
14-336
ＴＡ０８ＡＥＢＥ１０４８０１５０７０１ＭＥＡＴ００
REGULATOR
ACCUMULATOR COVER
SPRING CAP
A
B
D
SPRING SEAT
TORQUE CONVERTER
CHECK VALVE
REGULATOR VALVE
LOCK-UP SHIFT VALVE
E
Springs
Stator reaction spring
Regulator valve spring A
Regulator valve spring B
Torque converter check valve spring
Lock-up shift valve spring
3rd accumulator spring
1st accumulator spring A
1st accumulator spring B
F
STOP BOLT
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
C
REGULATOR VALVE BODY
Inspect for scoring and damage.
VALVE CAP
VALVE CAP CLIP
Standard (New)-Unit: mm (in.)
Wire Diameter O.D.
4.5 (0.177) 35.4 (1.394)
1.85 (0.073) 14.7 (0.579)
1.6 (0.063) 9.2 (0.362)
1.2 (0.047) 8.6 (0.339)
1.0 (0.039) 6.6 (0.260)
2.5 (0.098) 14.6 (0.575)
2.4 (0.094) 18.6 (0.732)
2.3 (0.091) 12.2 (0.480)
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
3RD ACCUMULATOR
PISTON
G
H
1ST ACCUMULATOR
PISTON
O-RING
Replace.
Free Length No. of Coils
30.3 (1.193)
83.0 (3.268)
44.0 (1.732)
33.8 (1.331)
35.5 (1.398)
29.4 (1.142)
49.0 (1.929)
31.5 (1.240)
1.92
16.9
12.5
12.2
18.2
4.9
7.1
6.6