Honda Accord 2008 Manual page 1255

07/11/02 09:17:15 61TA0000_160_0016
Driveline/Axle
Driveshaft Reassembly (cont'd)
Outboard Joint Side
1. Wrap the splines with vinyl tape (A) to prevent
damaging the outboard boot.
＊１５
2. Install the new ear clamp bands (B) and outboard
boot, then remove the vinyl tape. Be careful not to
damage the outboard boot.
3. Install a new stop ring (A) in the driveshaft groove
(B).
＊１６
16-16
B
Replace.
B
A
Replace.
4. Pack about 35 g (1.2 oz) grease included in the new
outboard boot set into the driveshaft hole in the
outboard joint.
NOTE: If you are installing a new outboard joint,
the grease is already installed.
A
Use the grease included
in the outboard boot set.
5. Insert the driveshaft (A) into the outboard joint (B)
until the stop ring (C) is close to the joint.
A
B
C
Push.
Push.
＊１７
＊１８