Honda Accord 2008 Manual page 820

07/11/02 09:25:09 61TA0000_130_0047
Special Tools Required
• Driver, 40 mm I.D. 07746-0030100
• Attachment, 30 mm I.D. 07746-0030300
NOTE: Refer to the Exploded View, as needed, during
this procedure.
1. Clean all parts in solvent, dry them, and apply MTF
to all contact surfaces.
2. Install the distance collar, needle bearing, and 1st
gear onto the countershaft.
3. Install the triple cone synchro assembly (A) by
aligning the synchro cone fingers (B) with the 1st
gear grooves (C), then install the synchro spring (D).
＊０２
4. Install the 1st/2nd synchro hub (A) by aligning the
synchro ring fingers (B) with the 1st/2nd synchro
hub grooves (C).
＊０３
5. Install the reverse gear.
D
A
B
C
6. Install the synchro spring (A).
7. Install the triple cone synchro assembly (B) by
aligning the synchro ring fingers (C) with the 1st/
2nd synchro hub grooves (D).
8. Install the distance collar (A) and friction damper
(B) by aligning the friction damper fingers (C) with
the 1st/2nd synchro hub grooves (D).
A
C
B
B
A
C
D
A
B
C
D
13-47
＊０４
＊０５
(cont'd)