Source (Port Monitoring) - Dell S6000 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.11.1
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage The monitoring command is saved in the running configuration at the Monitor
Information Session mode level and can be restored after a chassis reload.
Example
Dell(conf-mon-sess-0)#do show running-config monitor session
!
monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/33
direction tx
!
Related
monitor session
Commands
show monitor session

source (port monitoring)

Configure a port monitor source.
S6000
Syntax
source interface | range destination interface direction {rx |
tx | both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source
interface
Port Monitoring
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— creates a session for monitoring.
— displays a monitor session.
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
1081