Source (Port Monitoring) - Dell Force10 S4810P Reference Manual

Related
monitor session
Commands
show monitor session

source (port monitoring)

Configure a port monitor source.
C-Series, E-Series, S-Series, Z-Series
Syntax source interface destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
interface
destination
direction {rx | tx |
both}
Defaults none
Command Modes MONITOR SESSION (conf-mon-
Command History
Version 8.3.11.1
Version 8.5.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
1274
– Creates a session for monitoring.
– Displays a monitor session.
Enter the one of the following keywords and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
Enter the keyword destination to indicate the interface
destination.
Enter the keyword direction followed by one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
sess-session-ID )
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.