Dell MXL 10GbE Reference Manual page 1542

Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage Syslog messages contain the IP address of the interface used to egress the router.
Information By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
logging— enables logging to the Syslog server.
Commands
show logging
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number
history
reverse
summary
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
1542
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
(OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
(OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
(OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
EXEC
EXEC Privilege
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
PMUX Mode of the MXL 10/40GbE Switch I/O Module