Avaya S8700 Maintenance Manual page 584

Maintenance Commands
Drop Reason
(cont'd)
7-328 Issue 1 May 2002
Clearing received from DS1—The disconnect came from the
Endpoint
endpoint. The endpoint notified the MCU that it intended to disconnect.
Clearing received from DS1—The disconnect came from either
Far-end
the network or the endpoint.
Handshake Either framing was never found (the endpoint could not
complete initialization—Problems finding Frame Alignment Signal (FAS),
Multi Frame Alignment (MFA) and getting a corrected coded cap-set) or
framing was lost for some time (over 40 seconds) and the endpoint was
disconnected.
IDtimeout— The MCU has not received response to the UIN/password
Query from the H.320 user after three attempts. Each attempt has a
system administered timeout period.
MCU has a problem allocating trunk resources necessary to
Internal
route the dial-out call for the specified dial-numbers. This problem can be
associated with routing pattern or trunk associated translation (for
example, TAC specified in the dial-out number or routing pattern points to a
trunk group without members), or it can indicate a lack of trunk resources
(for example, every trunk member is maintenance busy or every in-service
member is busy on a call).
Network Clearing received from DS1—The disconnect came from the
network. The endpoint that had the disconnect notification capability
disconnected without notifying the MCU.
The dial-out destination number(s) of the "CAS" extension has
Not-MCU
terminated to a number that is not a dial-in cascade MCU extension.
No-ring This dial-out drop reason occurs when the call has been up for
30 seconds and no ringing is detected.
Reorder This dial-out drop reason occurs when the MCU detects that
there are no available trunks in the network to place the call. This drop
reason is detected by MCU CPTR resources. See "Dial-out" for a
description of CPTR usage.
555-233-143