Show Frrp - Dell MXL 10GbE Reference Manual

Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage This command places you into the resilient ring protocol. After executing this
Information command, the command line prompt changes to conf-frrp.

show frrp

Display the resilient ring protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id
summary
Defaults none
Command EXEC
Modes
Command
Version 9.2(0.0)
History
Usage Executing this command without the optional ring-id command clears the
Information
statistics counters on all the available rings. The system requires a command line
confirmation before the command executes. This command clears the following
counters:
•
•
•
Example
Dell#show frrp summary
(Summary)
Ring-ID State Mode
----------------------------------------------
2
31
50
Dell#
Example (1)
Dell#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : GigabitEthernet 0/16 State: Forwarding
532
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the ring identification number. The range is from 1 to
255
(OPTIONAL) Enter the keyword summary to view just a
summarized version of the Ring configuration.
Introduced on the MXL 10/40GbE Switch IO Module.
hello Rx and Tx counters
Topology change Rx and Tx counters
The number of state change counters
Ctrl_Vlan Member_Vlans
UP Master
UP Transit
Down Transit
2 11-20, 25,27-30
31 40-41
50 32
Force10 Resilient Ring Protocol (FRRP)