Fip-Snooping Fc-Map - Dell MXL 10GbE Reference Manual

fip-snooping fc-map

Configure the FC-MAP value FIP snooping uses on all VLANs.
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
Parameters
fc-map-value
Defaults 0x0EFC00
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Version 8.3.16.1
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-
mode fcf command.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information
518
Enter the FC-MAP value FIP snooping uses. The range is
from 0EFC00 to 0EFCFF.
CONFIGURATION
VLAN INTERFACE
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
FIP Snooping