Redistribute Command - Dell N1100-ON Reference Manual

Command
bgp cluster-id
bgp default local-preference
bgp fast-external-fallover
bgp fast-internal-fallover
bgp listen
bgp log-neighbor-changes
bgp maxas-limit
bgp router-id
clear ip bgp
clear ip bgp counters
default-information
originate (BGP Router
Configuration)
default-information
originate (IPv6 Address
Family Configuration)
default metric (BGP Router
Configuration)
default metric (IPv6 Address
Family Configuration)
distance
Description
Specifies the cluster ID of a route reflector.
Enables the network operator to specify the
default local preference.
Configures BGP to immediately reset the
adjacency with an external peer if the routing
interface to the peer goes down.
Configures BGP to immediately reset the
adjacency with an internal peer when there is a
loss of reachability to an internal peer.
Creates an IPv4 listen range and associates it
with the specified peer template.
Enables logging of adjacency state changes.
Specifies a limit on the length of AS Paths that
BGP accepts from its neighbors.
Sets the BGP router ID.
Resets peering sessions with all of a subnet of
BGP peers.
Resets all BGP counters to 0.
Enables BGP to originate a default route.
Allows BGP to originate an IPv6 default route.
Sets the value of the MED attribute on routes
redistributed into BGP when no metric has
been specified.
Sets the metric of redistributed IPv6 routes
when a metric is not configured in the

redistribute command.

Sets the preference of BGP routes to specific
destinations.
Dell EMC Networking CLI
a
Mode
BR
BR
BR
BR
BR,
IPAF
BR
BR
BR
PE
PE
BR
IPAF
BR
IPAF
IPAF
158