Redistribute - Dell Force10 Z9000 Reference Manual

mask
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage Although FTOS does not generate a route due to the backdoor config, there is an option for
Information injecting/sourcing a local route in the presence of network backdoor config on a learned route.

redistribute

Redistribute routes into BGP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected
static
route-map
name
382
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the keyword connected to redistribute routes from physically
connected interfaces.
Enter the keyword static to redistribute manually configured
routes.
These routes are treated as incomplete routes.
map-
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).