Table of Contents
Advertisement
ssh
Open an SSH connection specifying the hostname, username, port number, and version of the SSH
client.
Syntax
ssh {hostname | ipv4 address | ipv6 address} [-c encryption
cipher | -l username | -m HMAC alogorithm | -p port-number | -v
{1|2}]
Parameters
hostname
ipv4 address
ipv6 address
prefix-length
-c encryption
cipher
-l username
-m HMAC
algorithm
FIPS Cryptography
(OPTIONAL) Enter the IP address or the hostname of the
remote device.
(OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the following encryption cipher to use. (For v2 clients
only.) Without the FIPS mode enabled:
•
3des-cbc: Force ssh to use 3des-cbc encryption cipher.
With the FIPS mode enabled:
•
aes128–cbc: Force ssh to use the aes128–cbc
encryption cipher.
•
aes256–cbc: Force ssh to use the aes256–cbc
encryption cipher.
(OPTIONAL) Enter the keyword —l then the user name used
in this SSH session. The default is the user name of the user
associated with the terminal.
Enter one of the following HMAC algorithms to use. (For v2
clients only.):
Without the FIPS mode enabled:
•
hmac-sha1: Force ssh to use the hmac-sha1 HMAC
algorithm.
•
hmac-shal-96: Force ssh to use the hmac-sha1–96
HMAC algorithm.
•
hmac-md5: Force ssh to use the hmac-md5 HMAC
algorithm.
•
hmac-md5–96: Force ssh to use the hmac-md5–96
HMAC algorithm.
With the FIPS mode enabled:
•
hmac-sha1: Force ssh to use the hmac-sha1 HMAC
algorithm.
513
Advertisement
Table of Contents
