Ip Pim Spt-Threshold - Dell S4810 Reference Manual

Version 7.8.1.0
Version 7.7.1.1
Usage This command configures an expiration timer for all S.G entries, unless they are
Information assigned to an Extended ACL.

ip pim spt-threshold

To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
S4810
Syntax
ip pim spt-threshold value | infinity
To return to the default value, use the no ip pim spt-threshold command.
Parameters
value
infinity
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version
8.3.12.0
Version 8.1.1.0
Usage This command is applicable to last hop routers on the shared tree towards the
Information rendezvous point (RP).
1282
Introduced on the C-Series for the port-channels and the S-
Series.
Introduced
(OPTIONAL) Enter the traffic value in kilobits per second. The
default is 10 packets per second. A value of zero (0) causes a
switchover on the first packet.
(OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
PIM-Sparse Mode (PIM-SM)