Ip Pim Register-Filter - Dell Z9500 Command Reference Manual

ip pim register-filter

To prevent a PIM source DR from sending register packets to an RP for the specified multicast source and
group, use this feature.
Z9500
Syntax
ip pim [vrf vrf-name] register-filter access-list
To return to the default, use the no ip pim [vrf vrf-name] register-
filter access-list command.
Parameters
vrf vrf-name
access-list
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
Usage The access name is an extended IP access list that denies PIM register packets to
Information RP at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
PIM-Sparse Mode (PIM-SM)
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
Enter the name of an extended access list. Maximum 16
characters.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Introduced
1383