Atm Vc-Per-Vp - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

atm vc-per-vp

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
atm vc-per-vp [ vcCount ]
no atm vc-per-vp
Command introduced before JunosE Release 7.1.0.
Configures the number of virtual circuits per virtual path. This command controls the VPI
and VCI range on the ATM interface. The allowable configuration range depends on the
line module. The router will not execute the command if any virtual circuits are open on
the interface. The no version restores the default.
NOTE: This command is not available for ATM interfaces on the E120 router
and the E320 router because they support the entire VPI/VCI range.
The minimum number of VCs per VP is 4096 for OC3-4 modules and 1024
for T3 ATM modules. If you enter a value that is below the minimum, the
router uses the minimum value.
VCs and VP tunnels must not exist when you issue this command. If they do,
you must delete the VC and VP tunnel configuration before you issue this
command.
vcCount—Number of virtual circuits per virtual path
Interface Configuration
Chapter 2: A Commands
187