Area Range - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

area range

Syntax
Release Information
Description
Options
Mode
130
For OSPFv2:
[ no ] area { areaId | areaIdInt } range ipAddress mask [ do-not-advertise ]
[ cost costValue ]
For OSPFV3:
[ no ] area { areaId | areaIdInt } range ipv6Prefix/ipv6PrefixLength
[ do-not-advertise | advertise | cost costValue ]
Command introduced before JunosE Release 7.1.0.
cost keyword and costValue variable for OSPFv2 added in JunosE Release 8.1.0.
Aggregates routes at an area boundary. By default, the range of configured networks is
advertised in type 3 (summary) LSAs. The no version disables this function.
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value in the range 0–4294967295
ipAddress—IP address to match
mask—IP address mask
ipv6Prefix—IPv6 network number to match
ipv6PrefixLength—Length of the IPv6 prefix; a decimal value that indicates how many
of the higher-order contiguous bits of the IPv6 address make up the prefix (the network
portion of the IPv6 address). A slash (/) must precede this value.
do-not-advertise—Specifies that the range of configured networks is not advertised
advertise—Specifies that the range of configured networks is advertised (IPv6 only)
costValue—Cost value for the specified range of networks in the range 0–65535
Router Configuration
Copyright © 2010, Juniper Networks, Inc.