Address - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

address

Syntax
Release Information
Description
Options
Mode
84
To set the tunnel endpoint address:
address serverAddress
no address
To configure RIP:
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
To configure NAT address pool ranges:
[ no ] address startIpAddress endIpAddress
Command introduced before JunosE Release 7.1.0.
From Domain Map Tunnel Configuration mode, sets the tunnel endpoint address of an
L2TP tunnel. The no version removes the address of the tunnel.
From Tunnel Group Tunnel Configuration mode, sets the tunnel endpoint address of an
L2TP tunnel. The no version removes the address of the tunnel.
From Interface Configuration or Subinterface Configuration mode, configures RIP to run
on the interface specified by the IP address or on an unnumbered interface. Uses the
default values: send version is RIP version 1, receive version is RIP version 1 and version 2,
authentication is not enabled. The no version deletes the RIP interface. Use the address
commands to configure RIP attributes on the network.
From IP NAT Pool Configuration mode, configures NAT IP address pool ranges. The no
version removes the range from the current NAT address pool.
serverAddress—IP address of the LNS endpoint
ipAddress—Address of IP interface where RIP will be run
unnumbered—Specifies that RIP will be run on an unnumbered interface
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
startIpAddress—Starting IP address (inclusive) of the NAT pool range you are creating
endIpAddress—Ending IP address (inclusive) of the NAT pool range you are creating
Address Family Configuration (RIP), Domain Map Tunnel Configuration, IP NAT Pool
Configuration, Router Configuration (RIP), Tunnel Group Tunnel Configuration
Copyright © 2010, Juniper Networks, Inc.