Address Retransmit-Interval - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

address retransmit-interval

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
retransmit-interval retransInterval
Command introduced before JunosE Release 7.1.0.
Specifies the time between LSA retransmissions for the interface when an
acknowledgment for the LSA is not received. The no version restores the default value.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
retransInterval—Number in the range 0–3600 seconds; default value is 5 seconds
Router Configuration
Chapter 2: A Commands
103