Address Priority - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

address priority

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
priority intfPriority
Command introduced before JunosE Release 7.1.0.
Sets the router priority. Used in determining the designated router for the particular
network. This designation only applies to multi-access networks. Every broadcast and
nonbroadcast multiaccess network has a designated router. The no version restores the
default value.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
intfPriority—Priority value, an 8-bit number in the range 1–255; default value is 1
Router Configuration
Chapter 2: A Commands
101