Configuring Ethernet Interfaces; Ethernet Overview - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

Chapter 5

Configuring Ethernet Interfaces

Ethernet Overview

This chapter describes how to configure Ethernet interfaces on E Series Broadband
Services Routers.
Most of the procedures described here do not apply to the Fast Ethernet management
port on the SRP module. You can, however, select and display statistics for that port
by using commands described in this chapter. For information about managing the
Fast Ethernet port on the SRP module, see JUNOSe System Basics Configuration Guide.
This chapter contains the following sections:
Ethernet Overview on page 175
Ethernet Interface Platform Considerations on page 176
Fast Ethernet I/O Modules on page 178
Gigabit Ethernet I/O Modules and IOAs on page 179
10-Gigabit Ethernet IOAs on page 191
Ethernet References on page 195
High-Density Ethernet on page 196
Managing Port Redundancy on Gigabit Ethernet I/O Modules on page 197
Configuration Tasks for Ethernet on page 198
Configuring the Physical Interface on page 199
Disabling Ethernet Interfaces on page 205
Monitoring Ethernet Interfaces on page 205
Ethernet modules support the following Ethernet interfaces:
Fast Ethernet
Gigabit Ethernet
10-Gigabit Ethernet
This section describes features that are available with Ethernet interfaces.
175
Ethernet Overview