Avp - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

avp

Syntax
Release Information
Description
Options
Mode
208
avp avpType action
no avp avpType
Command introduced in JunosE Release 7.2.0.
Configures the L2TP tunnel switching behavior for a specified L2TP AVP type. The no
version restores the default L2TP tunnel switching behavior for AVPs of the specified
type.
avpType—One of the following L2TP AVPs
bearer-type—L2TP Bearer Type AVP 18; by default, the router regenerates this AVP
at the outbound LAC session, based on the local policy that is in effect
calling-number—L2TP Calling Number AVP 22; by default, the router regenerates
this AVP at the outbound LAC session, based on the local policy that is in effect
cisco-nas-port—Cisco NAS Port Info AVP 100; by default, the router drops this AVP
action—One of the following actions that characterize the tunnel switching behavior;
currently, only the relay action is supported
relay—Causes the router to preserve the value of an incoming AVP of the specified
type when packets are switched between an inbound LNS session and an outbound
LAC session
L2TP Tunnel Switch Profile Configuration
Copyright © 2010, Juniper Networks, Inc.