address transmit-delay
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
transmit-delay transmDelay
Command introduced before JunosE Release 7.1.0.
Sets the estimated time it takes to transmit a link-state update packet on the interface.
The no version restores the default value.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
transmDelay—Link-state transmit delay, a number in the range 0–3600 seconds;
default value is 1 second
Router Configuration
Chapter 2: A Commands
105