Auto-Configure - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

auto-configure

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
auto-configure upperInterfaceType [ lockout-time { minValue maxValue | none } ]
no auto-configure upperInterfaceType [ lockout-time ]
Command introduced before JunosE Release 7.1.0.
Specifies the type(s) of dynamic encapsulations that are accepted or detected by the
static ATM 1483 interface. Optionally, specifies the lockout time range for the
encapsulation type. You can enter this command repeatedly in Subinterface Configuration
mode. The no version terminates detection of the specified encapsulation type or, if the
lockout-time keyword is specified, restores the lockout time range to its default values.
NOTE: Encapsulation type lockout is available for bridged Ethernet, IP, PPP,
and PPPoE encapsulation types.
upperInterfaceType—One of the following dynamic encapsulation types:
bridgedEthernet
ip
ppp
pppoe
minValue—Minimum lockout time in the range 1–86400 seconds (24 hours); default
value is 1 second
maxValue—Maximum lockout time in the range 1–86400 seconds (24 hours); default
value is 300 seconds (5 minutes)
none—Disables lockout for the specified dynamic encapsulation type
Interface Configuration, Subinterface Configuration
Chapter 2: A Commands
201