Address Cost - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

address cost

Syntax
Release Information
Description
Options
Mode
92
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier } cost intfCost
Command introduced before JunosE Release 7.1.0.
Specifies a cost metric for an OSPF interface. Used in the calculation of the SPF routing
table. The no version resets the path cost to the default.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
intfCost—Link-state metric cost; a number in the range 0–65535; default value is 10
Router Configuration
Copyright © 2010, Juniper Networks, Inc.