Atm Cell-Packing - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

atm cell-packing

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
atm cell-packing maxCellsPerPacket mcpt-timer timerIdentifier
no atm cell-packing
Command introduced before JunosE Release 7.1.0.
Configures cell concatenation parameters for an ATM 1483 subinterface that provides
ATM layer 2 services over MPLS with virtual channel connection (VCC) cell relay
encapsulation. The no version restores the default cell concatenation parameters for
the subinterface.
NOTE: See the atm mcpt-timers command for information about configuring
systemwide values for the three ATM Martini cell packing timers to define
the cell collection time threshold.
maxCellsPerPacket—Maximum number of ATM cells in the range 1–190 that the router
can concatenate in a single VCC cell relay–encapsulated packet and transmit on an
MPLS pseudowire connection; default value is 1 cell per packet
timerIdentifier—Integer in the range 1–3 that identifies which of the three ATM Martini
cell packing timers (timer 1, timer 2, or timer 3) you want to use to detect timeout of
the cell collection time threshold; default value is 1. When the timer expires, the router
forwards the packet even if the number of concatenated ATM cells in the packet is
fewer than the specified maximum number of cells per packet.
Subinterface Configuration
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation in the JunosE BGP
and MPLS Configuration Guide
Chapter 2: A Commands
163