Baseline Hdlc Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

Software for e series broadband services routers command reference a to m
Table of Contents

Advertisement

baseline hdlc interface

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
baseline hdlc interface interfaceType interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Sets a statistics baseline for Cisco HDLC interfaces. The router implements the baseline
by reading and storing the statistics at the time the baseline is set and then subtracting
this baseline whenever baseline-relative statistics are retrieved. There is no no version.
interfaceType—One of the following interface types listed in Interface Types and
Specifiers on page 5
pos
serial
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Privileged Exec
Chapter 3: B Commands
225

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 and is the answer not in the manual?

This manual is also suitable for:

Junose 11.3

Table of Contents