Atm Oam - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

atm oam

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ]
[ cc { source | sink | both } ] ]
no atm oam [ vpi ] [ [ seg-loopback | end-loopback [ loopback-timer time ] ] ]
Command introduced before JunosE Release 7.1.0.
Configures F4 OAM on an interface or circuit. The no version deletes F4 OAM circuits.
NOTE: If you do not specify any options, both F4 end-to-end OAM and F4
segment OAM are enabled on all VPIs on the interface.
vpi—VPI on which you want to enable F4 OAM. If you do not specify a VPI, F4 OAM
flow is enabled on all VPIs on the interface.
seg-loopback—Enables F4 segment OAM
end-loopback—Enables F4 end-to-end OAM
loopback-timer—To generate F4 loopback cells on the VPI, you must configure the
loopback timer; you can set the loopback timer only for end-to-end loopback
time—Time interval in the range 1–600 seconds between transmissions of F4 loopback
cells.
cc—Enables CC cells on the PVC; you can enable CC cells only on data circuits, not on
control circuits, such as ILMI or signaling circuits
sink—Enables this VC as a sink point (cell receiver)
source—Enables this VC as the source point (cell generator)
both—Enables this VC as both a sink point and a source point
Interface Configuration, Subinterface Configuration
Chapter 2: A Commands
175