Address Authentication Message-Digest - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

address authentication message-digest

Syntax
Release Information
Description
Options
Mode
88
[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier } authentication
message-digest
Command introduced before JunosE Release 7.1.0.
Specifies that MD5 authentication is used for the OSPF interface. The no version sets
authentication for the interface to none, but leaves any configured MD5 key intact.
NOTE: You must issue the address area command before issuing this
command.
ipAddress—OSPF interface address previously specified with the address command
unnumbered—Indicates that OSPF is running on an unnumbered interface previously
specified with the address command
interfaceType—Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
Router Configuration
Copyright © 2010, Juniper Networks, Inc.